Page 1 of 1

How to make a Label Material in Thea Render 2

Posted: Sat Nov 24, 2018 9:06 pm
by Ron Walker
In stock Cinema labels are easy to make and no problem to render over another material. In Thea however any label material I make cuts out a hole right through all materials stacked. How can I fix this
Holes.jpg
Holes.jpg (253.73 KiB) Viewed 546 times

Re: How to make a Label Material in Thea Render 2

Posted: Mon Nov 26, 2018 11:19 am
by masterzone
Hi! usually on all rendering engine there is the channel for cut out knows as: Alpha channel or opacity.
I don't know Thea render but I think there is a dedicated channel :)