- logo.jpg (83.22 KiB) Visto 356 volte
- Site Admin
- Messaggi: 7939
- Iscritto il: ven set 17, 2004 5:34 pm
- Località: Verona
The best way to model a fluffy logo or balloon logo is start with a poly object and extrude it...see some steps below...
1) add an empy object
2) in point mode make quadrangular points
3) create polygons with bridge tool or polygon pen tool
4) extrude all polys with extrude tool (with caps option turned on)
5) put all into subdivision surface
6) put a phong tag into poly object
with this kind of steps you can make all softy object without spline
You can also make cut with knife tool if you need some parts more bubble...
ps: sorry I've inverted pictures steps...the last is the first