Pagina 1 di 1

geometry problem

Inviato: ven mar 01, 2019 8:21 pm
da doriang
Hi everyone.
I received an obj from a friend but this has a problem:
all the faces seem to be separate, so when I insert a subdivision surface I have a problem (as you can see in the attached images).
Does anyone know a solution for this?

Re: geometry problem

Inviato: sab mar 02, 2019 12:21 am
da MarkoDer
Go in edge mode and use the dissolve tool in order to create all quadrangle, the triangles must be avoided, after that use the optimize tool

Re: geometry problem

Inviato: sab mar 02, 2019 9:58 am
da doriang
Thank you so much. I had also arrived at this solution, trying everything.
Thanks again.

Re: geometry problem

Inviato: sab mar 02, 2019 10:00 am
da doriang
but instead of "dissolve" I use "melt" seems to work better .. I do not know why